The transmission shaft is a very important component in an off-road vehicle, its task is to transfer the drive torque to the front axle and rear. Normally a 4x4 is provided with two trees (one for each axis) which in the off-road driving are always subject to strong forces. In addition we must consider that often in a jeep run the preparatory work on the suspension to increase the height of the medium. This inevitably leads to more stress for the trees whose universal joints operate at larger angles. A raised suspension altering the geometries and distances between the splitter and the differential for which the shaft coupling has a lower work surface.
The XT AUTOMOTIVE shafts, replacing the originals, ensure reliability of the medium and a complete transfer of the engine torque without unnecessary friction. all-steel reinforced and made of high quality manufactured with a robust design our trees are available in different configurations: single and double Double cruise cruise. The solution with double joint allows us to work with more extreme angles.
The product is fully greasable and overhauled for complete protection of cruises, forks, bearings by foreign agents (sand, mud, water). The rotation and balancing tests are performed by special machines that simulate load conditions and use of all the transmission member. The XT AUTOMOTIVE shafts is entirely MADE IN ITALY.